Rubbermaid Raised Toilet Seat With Handle - 1ea

1. Read all instructions before attempting to install product. 2. Lift lid/seat assembly of toilet and place raised toilet seat on rim of bowl. The toilet seat has been designed to fit a wide range of toilet bowl sizes. Some bowls may require the removal of the existing lid/seat assembly for proper fit. The toilet seat must rest on the rim of the toilet with rear flanges (A) under the rear edge of the rim (see illustration). The pusher (B) must clear the front rim in order for the product to rest properly. The adjusting knob (C) can be rotated to adjust the position of the pusher. 3. When the toilet seat is resting properly on the rim, straighten the product so that it is centered on the toilet bowl. Turn the adjusting knob clockwise to tighten the product and lock it into place. Do not use tools to tighten the knob, hand tighten only. When the product is locked in place it is ready for use. Remember to check the fit occasionally and re-tighten if necessary. Manufacturer bears no responsibility for improper installation. Check periodically to see if knob requires tightening. Removal: 1. Rotate the adjusting knob counter-clockwise until it is loose. 2. Lift the front of the product and pull forward to remove from toilet. Use and Care Instructions: Use extreme caution on wet surfaces. Persons with reduced physical or mental capacity should be assisted during bathroom activities. For best results, use a non-abrasive mild detergent or household cleaner in warm water to clean. Rinse thoroughly with warm water. Do not use abrasive cleaners.

For E-Z Lock Raised Toilet Seats with Arms. Do not use arms for transferring a person from a wheelchair to toilet seat. Arms are to be used only for providing support in raising or lowering the user on and off of the seat.