Optimum Wetting and Rewetting Drops - 1 ounce
Optimum Wetting and Rewetting Drops - 1 ounce
- SKU: 119495
- UPC: 03467210270
- Size: 1 OZ
- Manufacturer: LOBOB
Wet lenses prior to insertion. These sterile drops are for rigid gas permeable contact lenses: Contains no polyquad, chlorhexidine, polyaminopropyl biguanide, or BAK. Not tested on animals.
Also use directly in the eye during the wearing cycle to relieve occasional dryness and discomfort. For use: Always wash and rinse your hands before handling your contact lenses. Clean and rinse the right lens first (always the same lens to avoid mix-ups). Wetting: Remove the right lens from the lens storage case and rinse thoroughly as directed by your eye care practitioner (all disinfecting and storage solution must be rinsed from the lens before wetting with product and inserting the lens). Apply 2 drops of product over all surface of the lens without rubbing the lens. Insert the lens as instructed by your eye care practitioner. Repeat the procedure with the left lens. Lubricating: When your lenses feel dry, apply no more than two (2) drops directly in the eye.
Sodium and Potassium Chloride Salts; Polyvinylpyrrolidone; Polyvinyl Alcohol; Hydroxyethyl Cellulose; Sodium Bisulfite 0.02%; Preserved with: Benzyl Alcohol 0.1%; Sorbic Acid 0.05%; Disodium Edetate 0.01%
Contains sodium bisulfite, a sulfite that may cause serious allergic reactions (e.g. hives, itching, wheezing, anaphylaxis) in certain susceptible persons. Although the overall incidence of sulfite sensitivity in the general population is low, it is seen more frequently in asthmatics or in atopic non-asthmatic persons. If you are allergic to sodium bisulfite or any other ingredient in this product, do not use. Close cap after each use. To avoid contamination, do not touch dropper tip to any surface. Please note carefully the ingredients as listed. If you are allergic to sodium bisulfite or any other ingredient in this product, do not use. Always wash and rinse hands before handling your lenses. After inserting your lenses, always empty your lens storage case, rinse, and allow to air dry. Store at room temperature 15-30 degrees C (59-86 degrees F). Keep out of reach of children. NOT for use with soft (hydrophilic) contact lenses. To protect against loss, always be sure sink drain is closed prior to rinsing lenses. SEE PACKAGE INSERT FOR IMPORTANT SAFETY INFORMATION.
